They cannot fall over, unless the sides collapse catastrophically (they are open, ladder-like assemblies predrilled for shelf supports. So the bookshelves are essentially wedged into place against the ceiling. With books filling the bookshelves, you can’t see the 1x2s. Then I tightened the adjustable feet to make sure it was tight. I just set them up then, screwed a piece of 1x2 to the side of each bookshelf close to the wall, snugged up tight to the ceiling. The bookshelves are floorstanding but quite tall, standing about 4 inches below the ceiling. In case it is helpful at all, I’ll post what I ended up doing. The only way there isn’t is if it’s solid concrete in which case that’s easy Even if it is solid plaster there should still be some structural element you could fasten to. If you do need to anchor through whole wall you can put a wall mounted coat rack or shelf on the other side or hang a picture or painting over bolts. Just away from potential electrical or plumbing and limit drill depth to about an inch. (Or previous homeowner special who knows what.) 5" From floor Could Just Be Lots Of Debris In Wall cavity, I Would Suggest Going up higher, Maybe 3’ or at your actual height, And doing s series of small,Easily Patchable, Like 1/8"-1/4" Test holes in a pattern to Try And find lathe(if it’s plaster) Probably 3 Holes At 3/4-1" Apart vertically Also Maybe 1-2’ Over another Set. What Bit did you drill with? I Think A Standard Bit in a non-hammer Drill Would Have decent Resistance If It Was Solid Plaster. I’m not the most experienced to comment since I’ve got limited regional and condo experience.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |